2. Product Overview
UMX-HDMI-140 series– User's Manual
14
Applied firmware package: v1.2.0 | LDC software: v2.4.1b7
2.1. Front View
1
VGA input
D-SUB connector for analog video signal.
2
Audio1 input
3.5 mm Jack connector for asymmetric analog audio input signal.
3
HDMI input
HDMI connector for DVI video or HDMI video and audio.
4
DisplayPort input
DisplayPort connector for DisplayPort audio/video signal.
5
Input Status LEDs
LEDs give feedback about the current status of the unit and input signals.
See the details in the next section.
6
Video Select
button
Button for switching between video sources.
7
Reset button
Pushing the button reboots the unit.
8
Audio Select
button
Button for switching between audio sources.
9
Show Me button
Special functions can be reached using this button (bootload mode, DHCP
settings, restore factory default settings, condition launching in
).
INFO:
Both UMX-HDMI-140 and UMX-HDMI-140-Plus have the same look and controls on the front panel.
1
7
2
3
4
5
6
8 9
Status LEDs
Input Status LEDs
OFF:
Input is not selected.
BLINKING:
Input is selected, and signal is not detected.
ON:
Input is selected and signal is present.
ATTENTION!
When Dark mode is enabled, input status LEDs are off, even though the device is fully
functional.
LIVE LED
OFF:
Device is not powered.
BLINKING: (slow, 1 sec)
Device is powered and operational.
BLINKING: (fast, 0,5 sec)
Device is in firmware upgrade mode.
ON:
Device is powered but not operational.
AUTOSELECT LED
OFF:
Autoselect function is disabled.
BLINKING:
Autoselect function is enabled, searching for signal (the video input LEDs are also blinking).
ON:
Autoselect function is enabled, the active video signal is found (the selected video input's LED
is also ON).
