LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 95 / 133

AireLink

60 Installation and User Manual Rev. D CLI -- Command Line Interface
Page 95
7 CLI -- COMMAND LINE INTERFACE
The CLI interface has a Cisco-like command line interface with two modes of access levels:

User configuration

show command

Global configuration

configure command
In addition there are there are misc. command line instructions like ping , copy , and upgrade tftp .
To access the AireLink™ CLI interface please open the Windows command prompt and type >telnet
IP_address, e.g. telnet 192.168.1.10 (default setting)
The AireLink™ CLI access is protected from unauthorized access by login/password protection.
Default login/password is “admin”.
After successful login the AireLink 60> command prompt is displayed (see below).
The user mode contains a limited number of basic commands to display the device status. To view the
available commands, please type
? (See below).
While the user mode displays system parameters, the configure mode is used to change system
settings. After typing
configure the command prompt will change to AireLink 60(config)# (see
below). To return to the previous mode, please type exit . Typing the exit command from the user
mode command prompt will terminate the CLI session.