LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 73 / 133

AireLink

60 Installation and User Manual Rev. D System Installation
Page 73
5.14 MOUNTING BRACKET ADJUSTMENT
At this point during the installation process the antennas should be attached to the mounting pole in
such a way that they roughly point towards each other. The alignment brackets fine adjust mechanisms
are used to precisely tune the antenna elevation and azimuth. The procedure described below is the
same for the 1 foot and 2 foot antenna.
Elevation Adjustment
To adjust the elevation settings of the antenna see Fig. 5-7 and perform the following steps:
1. Slightly loosen the 3 Elevation locking bolts.
2. Determine if elevation adjustment must be performed in upwards or downward direction.
3. In case the elevation must be adjusted upwards, ensure that the two Elevation Locking Bolts
marked I/II in Fig. 5-14 are both in position I . If not, keep the Pivot Bolt in place and unscrew
these two locking bolts. Support the antenna when removing the last/second bolt to avoid the
antenna sliding down. On the back of the alignment bracket is the lock bolt holder (see Fig. 5-
7) and it needs to be put in place again before re-inserting the bolts in position I . Do not
completely tighten the bolts to allow the antenna to move when turning the Elevation
Adjustment Screw.
Figure 5-14: Elevation Adjustment