LightPointe AireLink 60, Инструкция по установке и эксплуатации

Страница: 127 / 133

AireLink

60 Installation and User Manual Rev. D Advanced Troubleshooting Methods
Page 127
11.3 STEP-BY-STEP INSTRUCTIONS TO PERFORM A PING TEST
Step 1 Locate the required equipment listed above.
Step 2
On each side, attach an RJ-45 cable or optical fiber cables via SFP transceiver to the
radio port labeled DATA PORT. Connect the opposite ends of the RJ-45 cable to a laptop
or fiber cables to the TX/RX ports of the media converters.
Step 3 Connect an Ethernet cable between the PC RJ45 network port and the media converter
RJ45 port on each laptop/PC and complete the following setup instructions on each
laptop. The exact procedure will depend on the actual Windows operating system
installed but the procedure is basically the same for any Windows operating system.
Step 4 From Windows click the Start button.
Step 5 Click on Settings.
Step 6 Click on Control Panel.
Step 7 Click on the Network And Dial-Up Connector icon.
Step 8
Click on Incoming Connection.
Step 9
Click on the Network tab .
Step 10
Double click on Internet Protocol TCP/IP .
Step 11 Select the Specify TCP/IP Address radio button.
Step 12 The local side should type 192.168.1.1 in the IP Address Box. The remote side should
type 192.168.1.10 in the IP address box. The Subnet address will automatically
generate.
Step 13 Click the Okay button.
Step 14 Exit all dialog boxes.
Step 15 Click on the Start button.
Step 16 Select Programs .