Lighthouse Worldwide Solutions ApexR02p, Руководство оператора

Страница: 33 / 74

ApexRp Operators Manual
248083480-1 Rev 3 32
DIP Switch Addressing
Table 4-3 details the addresses set by the binary DIP switches 1-5.
DIP SWITCHES
12345
ADDRESS DIP SWITCHES
12345
ADDRESS
0 0 0 0 0 Do Not Use 0 0 0 0 1 16
1 0 0 0 0 1 1 0 0 0 1 17
0 1 0 0 0 2 0 1 0 0 1 18
1 1 0 0 0 3 1 1 0 0 1 19
0 0 1 0 0 4 0 0 1 0 1 20
1 0 1 0 0 5 1 0 1 0 1 21
0 1 1 0 0 6 0 1 1 0 1 22
1 1 1 0 0 7 1 1 1 0 1 23
0 0 0 1 0 8 0 0 0 1 1 24
1 0 0 1 0 9 1 0 0 1 1 25
0 1 0 1 0 10 0 1 0 1 1 26
1 1 0 1 0 11 1 1 0 1 1 27
0 0 1 1 0 12 0 0 1 1 1 28
1 0 1 1 0 13 1 0 1 1 1 29
0 1 1 1 0 14 0 1 1 1 1 30
1 1 1 1 0 15 1 1 1 1 1 31
Table 4-3 DIP Switch Addressing
Communicating Serial with ApexRp Instrument
Serial Data / Power Port
The ApexRp is equipped with the Serial COM Port shown in Figure 4-2
to communicate to an RS-485 network incorporating LMS equipment,
such as the LMS 485 Gateway and Lighthouse System Control
Cabinet.
Note:
Because Address 0
is reserved for
broadcasting in MODBUS
RS-485 communications,
Address 1 is the lowest
DIP switch setting that
can be used. All switches
OFF can cause
communication failures
on the network and must
not be used.