R E E D P R E M I E R
MOUNTING INSTRUCTIONS
12371.000.000 Rev M
CONTINUES ON BACK
S C R E W M O U N T
1. Kit includes two (2) bracket clips, two (2) screws
(Fig. 1)
.
2. Screw bracket clip to shelf in desired location (approximately 12”
spacing centered under the shelf), ensuring that both clips are
oriented in the same direction
(Fig. 2)
.
3. Raise fixture to clip, aligning the channel on the back of fixture
with clip and snap in place
(Fig. 3 and Fig. 4)
.
4. Plug DC cord to either end of fixture and route to power supply.
5. If equipped with an occupancy sensor, connect the third screw
bracket clip in-line with the two already installed, and
approximately 2” from the end of the fixture. Connect the sensor to
fixture and snap into place
(Fig. 12)
.
6. Place power supply on any horizontal surface, allowing the plug to
be inserted into 120V AC, 60Hz, grounded outlet
(Fig. 11)
.
S T A N D A R D M A G N E T I C M O U N T
1. Magnetic clips attach by clamping to the back surface of the
fixture housing, for direct mounting to metal shelving.
2. For all fixtures: use 1 magnetic clip per end located at the distance
specified for the given fixture length
(Fig. 7)
in the table below:
3. Locate fixture to the desired position on metal shelf
(Fig. 5)
and set
in place
(Fig. 6)
.
4. Plug DC cord to either end of fixture and route to power supply.
5. If equipped with an occupancy sensor, connect the standard
magnetic clip to the OS body and install
(Fig. 12)
.
6. Place power supply on any horizontal surface, allowing the plug to
be inserted into 120V AC, 60Hz, grounded outlet
(Fig. 11)
.
M A G N E T I C A N G L E M O U N T
1. Magnetic angle clips attach by clamping to the back surface of the
fixture housing for direct mounting to metal shelving.
2. For all fixtures: use 1 magnetic angle clip per end located at the
distance specified for the given fixture length
(Fig. 7)
in the table below:
3. Place one side of the clip against the fixture housing and press the
opposite side down until it snaps into place. Adjust clip positions
to the recommended position shown above, by sliding into place.
4. Locate fixture to the desired position on metal shelf
(Fig. 5)
and set
in place
(Fig. 6)
.
5. Adjust light output angle to desired direction by rotating the fixture
(Fig.
8)
. For best results, push on the edge of the fixture to change angle.
6. If clip doesn’t hold position, remove fixture and tighten with a T10
driver. To remove, pry off one edge gently with a flat head screw driver.
7. Plug DC cord to either end of fixture and route to power supply.
8. If equipped with an occupancy sensor, connect the standard
magnetic clip to the OS body and install using flexible cord
provided per the instructions on the reverse side.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Caution: Magnetic field present in magnet mount fixture.
FIXTURE FAMILY
Approximate clip distance
“X” from end of fixture
17”
1”
24”
3”
31”
3”
44”
6”
58”
9”
Fig. 7
Fig. 8
“X”
FIXTURE FAMILY
Approximate clip distance
“X” from end of fixture
17”
1”
24”
3”
31”
3”
44”
6”
58”
9”
