A.
Insert the lamp head into the lamp body
B.
Connect the cable female and male connector.
A.
Straighten the thread, insert it into the thread groove of
the slide block, and then attach the silicone pad.
B.
Then insert the slider into the wall mount.
Open the box and identify the various lamp accessories.
A.
Fix the wall mount on the wall and mark the drilling
points for the screws.
B.
Drill into the marked drilling points using a Ø6mm drill bit.
C.
Fix the installation colloidal particles in the installation hole
D.
Use a screw driver to fix the flat head cross tapping screws to
the wall.
Install the lamp body, plastic cover, wall mount, flat gasket, spring
washers, cylindrical head hexagon screws, with 5mm spanner to
lock them successively.
Plug in the power, touch the center of the lamp holder to light up,
long press to adjust brightness.
The lamp has a memory function, meaning it can remember your
last light intensity when turned off and on again
1
Installation instructions
Lamp body: 1pcs
Lamp head: 1pcs
Plastic cover: 1pcs
Wall mount: 1pcs
Sliding block: 1pcs
FLAT gasket: 1pcs
Plastic anchors: 4pcs
Screw: 1pcs
Screw: 4pcs
Spanner: 8mm, 5mm
& 2mm
Spring washer: 1pcs
2
3030
3939
18
18
35
35
A
B
C
D
3
6
5
4
Silicone pad
