LIFTGATOR VanGator, Руководство по сборке и эксплуатации

Страница: 11 / 18

Page | 11
9. Avoiding all pinch points, carefully grab the LiftGator’s crossmember
and roll the hitch out of the hitch receiver.
10. Insert the hitch pin back into the hole located on the LiftGator’s hitch
for storage.
11. Carefully push the LiftGator into a place of storage, preferably
indoors to avoid rusting and weathering.
12. It is recommended to lubricate all moving parts with white lithium
grease or a light oil and to check for damage to wire rope upon every
dismounting of the LiftGator. See “Maintenance Procedures and
Scheduling” for a complete list of maintenance checks.
Lifting Operation:
1. It is recommended that you install and uninstall the LiftGator on a hard,
even surface such as asphalt or cement.
2. Once your LiftGator is installed, with skates detached, fold the LiftGator
frame away from the vehicle by pushing on the lever.
3. Once the lift is lowered, you can open the van doors. Once the doors are
opened as wide as possible, you can raise the LiftGator back up by lifting
one of the uprights and pushing it back until it snaps back in to locked
position.
4. Before lowering the LiftGator, each stabilizer leg (with skates
DETACHED) must be deployed to the ground by pulling the stabilizer pin,
dropping the leg, and resetting the stabilizer pin. Preload each stabilizer
by rotating the cranks in the clockwise direction about 10 times or until
resistance can be felt in the crank.
5. Using the auto latch found on the right side of the platform, unfold the
platform center to the horizontal position and rotate the front flap 180
degrees to extend the platform.
6. Locate the platform switch on the upright “down” button until the
platform meets the ground. Note that the kick flap will automatically
fold to the vertical position when the platform is lowered.