Lift-Rite,
Tel:
Toll Free from USA: 1-800-558-6012, Greene, NY 13778, Publication Number 1130442/001E ©2022 Dated 23 Sep 2022
4
MAINTENANCE
LUBRICATION
All pivot points are equipped with permanently lubricated bushings and bearings. To increase
bearing life, it is recommended that a few drops of light machine oil be applied at each pivot point
every 6 months. The thrust plate is equipped with three grease fittings. Apply grease under normal
conditions every 6 months.
PUSH BAR LINKAGE ADJUSTMENT
If the forks do not rise evenly at the tips, or the roller levers begin to drag on the floor, the following
adjustment is necessary:
LCR55 MODEL
•
Turn the hand pallet truck over so that the underside of the forks are accessible.
•
Remove one split pin (PN-20269B) with a 3/16 in. punch.
•
Remove the pin (PN-20227) from the bracket.
•
Adjust the eyebolts (PN-20226). Turn counterclockwise to raise the fork tips and clockwise to
lower the fork tips.
•
Replace the pin (PN-20227, through the eyebolt and replace the split pin (PN-20269B).
•
When adjusted properly, the forks should be 3 in. low height from ground level in the lowered
position.
LCS55 MODEL
•
Turn the hand pallet truck over so that the underside of the forks are accessible.
•
Remove one split pin (PL-20269) with a 3/16 in. punch.
•
Remove the pin (PL-20227) from the bracket.
•
Adjust the eyebolts (PL-20226). Turn counterclockwise to raise the fork tips and clockwise to
lower the fork tips.
•
Replace the pin (PL-20227), through the eyebolt and replace the split pin (PL-20269).
•
When adjusted properly, the forks should be 3 in. (LCS) low height from ground level in the
lowered position.
