Lifevisa
W
IRELESS
B
IKE
C
ADENCE
S
ENSOR
[RPS-2300] U
SER
M
ANUAL
COMPONENTS
CADENCE SENSOR BATTERY INSTALLMENT
This Cadence Sensor includes a 3V CR2032 lithium battery.
Please follow below steps to install the battery.
Step 1.
Insert the battery (CR2032) with the positive (+) side up.
☆
Make sure the battery is hooked by the contact spring.
Step 2.
Put on the O-Ring in the groove to ensure water resistance.
☆
Make sure to place the O-Ring properly in order to prevent battery
composition from being spoiled by rain or water.
Step 3.
Place the battery cover and use a coin to twist it clockwise until it is tight
enough.
Thank you for purchasing Lifevisa products. This manual contains
information required to use Cadence Sensor. Please read this manual
thoroughly before you use the Cadence Sensor.
1
2
3
5 & 6
4
☆
The effective distance/range is within 10 meters. Be sure no other
devices are within this distance making the same approach.
HOST CONNECTION
This Cadence Sensor must be recognized to the host before being used
for the first time. We recommend making this approach before
installment. Please follow below instructions to complete the connection.
1. Turn on the host and enter
connection mode. The host will
wait the signal for 1 minute. If
not receiving the signal, the host
will exist the connection mode
2. Press the set key of Cadence Sensor. Then wait for connection.
set key
1. Cadence Sensor with Screw, Nut & Foam Pad
2. O-Ring
3. 3V CR2032 Lithium Battery
4. Battery Cover
5. Zip Tie for Cadence Sensor X 2pcs
6. Zip Tie for Cadence Magnet X 2pcs
7. Cadence Magnet with Screw & Nut
NOTE:
☆
Open the battery cover only when changing the battery to ensure a long life,
and make sure the O-Ring is not damaged, in which case you should replace
it with a new one.
☆
Keep battery away from children. If swallowed, contact a physician at once.
Batteries should be disposed of in compliance with applicable laws and
regulations.
7
1
2
3
3. The host should begin to display a reading, showing the connection has
been done and you can start to install the Cadence Sensor and Magnet.
