
24
LifeSize Gateway User Guide
LifeSize Gateway Unit Initial Configuration
Figure 2-4
Fitting a Bracket for Rack Mounting
4
Pass the screws through the brackets and tighten them into the
screw holes on each side of the LifeSize Gateway unit using a
suitable screwdriver.
5
Insert the LifeSize Gateway unit into the 19-inch rack.
6
Fasten the brackets to the side rails of the rack.
7
Make sure that the air vents at the sides of the LifeSize
Gateway unit are not blocked.
L
IFE
S
IZE
G
ATEWAY
U
NIT
I
NITIAL
C
ONFIGURATION
Initial monitoring and administration of the LifeSize Gateway unit are
performed from a remote PC via a serial connection. This allows you to access
the boot configuration menu of the LifeSize Gateway unit. At power-up, the
LifeSize Gateway unit goes through the following boot phases:
Auto-boot
—The embedded operating system initializes and displays
basic information.
Configuration menu
—A 6-second countdown allows you to enter
the configuration menu.
Содержание Gateway-PRI
