Description
The ADC-ACC1-17-PSE is a single door access control unit
featuring dual voltage power, an ADC-ACC1-17 controller,
and a preinstalled adapter plate for an ADC-ACX1 single
door reader board, housed in a 12”x14”x4.5” metal enclo-
sure with battery space.
Equipment List
1. Power Supply 24VDC / 3A (model: FPV4)
2. Secondary 12V supply (model: B100)
3. ADC-ACC1-17 controller
4. Mounted ADC-ACX1 expansion back plate
5. ADC-ACX1 mounting hardware
6. AC power cord
QUICK GUIDE
ADC-ACC1-17-PSE
Bracket for
ADC-ACX1 or
ADC-ACC1-17
Accessories included
• AC power cord
• Battery harness
• Bracket mounting hardware
October 2017
1/2
www.lifesafetypower.com
Terminal Output Ratings
**Max currents listed are for individual terminals - total current at 12V and 24V not to exceed max rating of supply
Board
Terminal
Voltage
Max Current**
Notes
FPV4
DC OUT
24V
1.5A
Output can be switched by FAI Input on FPV4
AUX OUT
24V
0.75A
Max Current includes current drawn by B100
B100
DC OUT
12V
1.5A
For additional 12V devices
J2 (DC OUT)
12V
1.5A
For additional 12V devices
J5 (DC OUT)
12V
1.5A
For additional 12V devices
J1 (DC IN)
24V
0.75A
For additional 24V devices
J4 (DC IN)
24V
0.75A
For additional 24V devices
ADC-ACC1-17
VO
12V
0.65A
Max Current includes reader current draw
1-C (NO or NC)
24V
1.5A
Switched Lock Output - Ground at FPV4 DC OUT (-) Terminal
System Operation
The FPV4 power supply converts AC primary power to 24VDC for charging the battery set and powering the B100, locking
device(s), and 24V auxiliary devices. The B100 is powered from the FPV4 Auxiliary terminals and steps the 24V down to
12V to power the ADC-ACC1-17 controller, reader(s), and any 12V auxiliary devices.
The battery set is charged by the red/black harness on the bottom edge of the FPV4. The battery set MUST be two 12V
batteries in series for a 24V battery set. Observe polarity or damage to the system will occur.
Positive lock power is prewired to the ADC-ACC1-17 lock relay terminal 1C. The lock positive should be wired to the NC
(Fail Safe) or NO (Fail Secure) terminal as appropriate. The lock negative should be wired directly to the FPV4 DC OUT (-)
terminal to minimize noise and surges in the system.
101317_rev1
