5
For Research Use Only. Not for use in diagnostic procedures.
Quick RefeRence
Limited Product Warranty
Life Technologies corporation and/or its affiliate(s) warrant their products as set forth in the Life
Technologies’ General Terms and conditions of Sale found on Life Technologies’ website at
www.lifetechnologies.com/termsandconditions
.
if you have any questions, please contact Life
Technologies at
www.lifetechnologies.com/support
.
Disclaimer
Life TecHnOLOGieS cORPORATiOn AnD/OR iTS AffiLiATe(S) DiScLAiM ALL WARRAnTieS WiTH ReSPecT TO
THiS DOcuMenT, eXPReSSeD OR iMPLieD, incLuDinG BuT nOT LiMiTeD TO THOSe Of MeRcHAnTABiLiTY,
fiTneSS fOR A PARTicuLAR PuRPOSe, OR nOn-infRinGeMenT. TO THe eXTenT ALLOWeD BY LAW, in nO
eVenT SHALL Life TecHnOLOGieS AnD/OR iTS AffiLiATe(S) Be LiABLe, WHeTHeR in cOnTRAcT, TORT,
WARRAnTY, OR unDeR AnY STATuTe OR On AnY OTHeR BASiS fOR SPeciAL, inciDenTAL, inDiRecT,
PuniTiVe, MuLTiPLe OR cOnSeQuenTiAL DA
MAGeS in cOnnecTiOn WiTH OR ARiSinG fROM THiS
DOcuMenT, incLuDinG BuT nOT LiMiTeD TO THe uSe THeReOf.
Important Licensing Information
This product may be covered by one or more Limited use Label Licenses. By use of this product, you accept the
terms and conditions of all applicable Limited use Label Licenses.
All trademarks are the property of Thermo fisher Scientific and its subsidiaries, unless otherwise specified.
©2014 Thermo fisher Scientific inc. All rights reserved.
4 September 2014
Countess
®
II
Countess
®
II FL
Automated Cell Counter
Catalog Numbers
AMQAX1000, AMQAF1000
Pub. no.
MAN0010826
Rev.
A.0
Changing EVOS
®
Light Cubes
Note:
For Countess
®
II FL (AMQAF100) only.
The countess
®
ii fL Automated cell counter can hold up to two eVOS
®
light cubes. Light
cubes do not come standard with the device and must be purchased separately.
To install a light cube:
1.
Turn off the instrument by flipping the power switch to the
OFF
position and unplug it
from the electrical outlet.
2.
unlatch the back panel of the instrument.
3.
using the tool provided on the inside of the back panel, loosen
the two screws (red arrows) that secure the light cube to the
instrument.
4.
Once the light cube is loosened, thread the tool into the center
hole in the cube (white arrow) and gently pull the light cube out of
the instrument.
5.
To install a light cube, put the cube into one of the two empty slots.
6.
using the light cube tool, tighten the two screws to securely attach
the cube to the instrument.
7.
Place the light cube tool into its slot inside the back panel, and then install the back
panel and secure it in its place.
8.
Plug the instrument back into the electric outlet and turn it on by flipping the power
switch to the
ON
position.
