12
5. Front Post, Tension Control Knob, and Front Post Cover Installation
Remove four Ø8xØ16x1.5T Washers (8), four M8x10 Hexagon Socket Pan Head Cap Bolts
(36), one Ø8xØ20x2.0T Big Curve Washer (2), and one M8x15 Hexagon Socket Flat Head
Cap Bolt (37) from the tube of the Front Main Frame (76). Remove bolts with the S6 Allen
Wrench provided.
Slide the Front Post Cover (38) up to the Front Post (87).
Insert the Tension Cable (32) through into the bottom hole of Front Post (87) and pull it out
from the square hole of Front Post (87).
Connect the Extension Hand Pulse Sensor Wire I (72) and Sensor Wire (74) from the Front
Main Frame (76) to the Extension Hand Pulse Sensor Wire II (29) and Extension Sensor
Wire (28) from the Front Post (87).
Insert the Front Post (87) onto the tube of the Front Main Frame (76) and secure with four
Ø8xØ16x1.5T Washers (8), four M8x10 Hexagon Socket Pan Head Cap Bolts (36), one
Ø8xØ20x2.0T Big Curve Washer (2), and one M8x15 Hexagon Socket Flat Head Cap Bolt
(37) that were removed.
First lightly tighten four M8x10 Hexagon Socket Pan Head Cap Bolts (36) and one M8x15
Hexagon Socket Flat Head Cap Bolt (37) by hand. After all five bolts are lightly
tightened by hand, the next step is to tighten the front M8x15 Hexagon Socket Flat Head
Cap Bolt (37) with the S6 Allen Wrench until firm. Then tighten the other four M8x10
Hexagon Socket Pan Head Cap Bolts (36)
on the side of the tube with the S6 Allen Wrench.
Slide the Front Post Cover (38) down to the Front Post (87).
A
B
32
31
31
32
C
D
31
32
32
31
Allen Wrench S6
Tool:
Multi Hex Tool with Phillips Screwdriver
S10, S13, S14, S15
74
38
2 37
8
36
34
35
31
32
8
36
72
87
32
76
29
28
