16
STEP 14:
FIGURE 14
STEP 15:
FIGURE 15
•
SECURELY
assemble the LAT/LOW ADJUST PLATE (21) to the LAT/LOW FRAME (14) using two BLACK RH CAPS (68),
two RH CAPS (69), two 3/8 X 67mm BOLTS (55), four 3/8” SAE WASHERS (66), four 3/8” RH WASHERS (67) and two 3/8” LOW
HEIGHT LOCK NUTS (65) as shown in FIGURE 14.
53 3/8 X 50mm
21
30
47
65
14
69
67
66
• Route the LAT CABLE (71) through the LAT/LOW BOOM (11) and assemble two 4-1/2” PULLEYS (26) to the BOOM (11) us-
ing two RH CAPS (69), two BLACK RH CAPS (68), two 3/8 X 70mm BOLTS (56), four 3/8” SAE WASHERS (66), four 3/8” RH
WASHERS (67), two 2-7/8” X 2-1/4” CABLE CLIPS (28), four 3/8 X 1/2” FLANGE SPACERS (46) and two 3/8” LOW HEIGHT LOCK
NUTS (65) as shown in FIGURE 15.
51 3/8 X 43mm
3/8 X 70mm 56
23
28
71
11
67
26
46
66
65
69
• Route the LAT CABLE (71) around one 4-1/2” PULLEY (26) and assemble the PULLEY to two DUAL PULLEY PLATES (23)
using two RH CAPS (69), one 3/8 X 43mm BOLT (51), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67) and one 3/8”
LOW HEIGHT LOCK NUT (65) as shown in FIGURE 15.
68 BLACK
69
BLACK 68
3/8 X 67mm 55
•
Assemble the 3/4 X 3-1/8” TAPPED SHAFT (30) to the LAT/LOW ADJUST PLATE (21) using two BLACK RH CAPS (68), one
3/8 X 50mm BOLT (53), two 3/8” SAE WASHERS (66), two 3/8” RH WASHERS (67), one 3/8 X 1/2” SPACER (47) and one 3/8” LOW
HEIGHT LOCK NUT (65) as shown in FIGURE 14.
(NOTE: Tighten connection enough to remove play, yet allowing TAPPED
SHAFT to rotate freely.)
68
69
68
BLACK
