LDCA608S Digital DC Servo Instruction Manual
LDCA608S Digital DC Servo Instruction Manual
第
7
页
第
8
页
P6 Motor brake signaltiming diagram
Note: t1: Delay brake opening time
t2: Delay brake closing time
三、
Parameter settings
This series of drivers can be set directly through the keypad of the driver. The
debugging panel and debugging steps are as follows
：
1
、
Introduction to the debug panel
Key
Key Description
Input bit (blinking) shift left
Switch sub menus, increase values
Switch sub-menus, decrease values
Enter submenu, confirm input
Switchable between modes
2
、
Data monitoring
LED display
Description
The current position error is converted to the number
of code disk lines
Current speed feedback (rpm)
Current speed reference (rpm)
Number of pulses after 4 times the frequency of the
current position feedback code disc, calculated from
power-on initialization
Given the original number of pulses at the current
position, it is calculated from power-on initialization
Current current peak (mA)
Displays the current fault value.
3
、
Operating procedures
Power On
Display
Data monitoring mode
Display monitoring value
Parameter setting mode
Display
parameter
values
Modify
parameter
values
Accessibility mode
Parameter write in
