Your browser will now load a special
SAFELERT Setup Web Page.
Follow the onscreen instructions to
complete your SAFELERT Sensor setup.
6
Open an internet browser on your
computer, smartphone or tablet.
In the address bar type:
10.5.5.2
and press
Enter or Go.
5
It may show you an error indicating that
you do not have an internet connection.
This is normal.
Tip
Go to the wireless (Wi-Fi) settings of
your computer, smartphone or tablet.
Search for available wireless networks
and connect to the Wi-Fi network named
Elertus
.
4
The Elertus Wi-Fi network cannot provide an
internet connection, but will provide access to
the SAFELERT setup web page.
Setup
page
Wi-Fi
Wi-Fi
When the LED light on your SAFELERT
Sensor is flashing
YELLOW
it is in a
special
setup mode
. You can connect
to it just like you would your home or business
Wi-Fi network.
3
Wi-Fi
Wi-Fi
Ensure that Wi-Fi is enabled on your computer,
smartphone or tablet, then continue.
Press and hold the little, white button
on the front of your SAFELERT Sensor
until the LED light flashes
YELLOW
.
2
You may need to hold the button down for
up to 15 seconds. The LED may blink other
colors before it begins flashing
YELLOW
.
Tip
Install the batteries into your
SAFELERT Sensor, and wait for the
LED light to turn solid
RED
.
1
A slot on the left side of the SAFELERT Sensor enables
you to pry the case open using a flathead screwdriver.
Tip
Before You Begin,
You Will Need
Your Liberty SAFELERT Sensor and the
included AA batteries.
A computer, smartphone or tablet with
Wi-Fi capability.
A flat-head screwdriver.
Your wireless (Wi-Fi) network name and
password. To make the setup easier, write
them in the space below:
Network Name: __________________________
Password: ________________________________
SAFELERT Setup Guide
POWERED BY
