Zhejiang Lianda Science & Technology Co.,Ltd.
TUBULAR MOTOR
NK1-R series
**Warning: Read the safety instructions before you start installation.If these instructions are not
followed, the LianDa's liability and warranty are forfeited. LianDa is not liable for any change in the
regulations and standards introduced after the publication of this manual.
I. Introduction
：
These products are used as electric drives and auto controls for shutters, rolling doors, awnings or allied mechanisms.
Complete motor has features of compact structure, easy operation, convenient installation and reliable performance, and widely
applies to residences, shops, hotels, garages, and so on.
II. Warnings:
1. Motor installation and adjustment should be operated by professional staff, using the appliance only in the described
manner.
2. Don't use or stop the use if the appliance is damaged, especially the electrical wire and sleeve.If the cable is damaged,it
must be replaced by the manufacturer,its service agent or similarly qualified person in order to avoid a hazard.
3. Children can’t recognize the risks of electrical appliances. Therefore use or keep the appliance only under supervision of
adults or out of the reach of children.
**
Important safety instructions. It is important to follow and keep these instructions for the sake of safety.
4. Don't operate the awning when maintenance, such as cleaning window, is being carried out in the vicinity.
5. Don't allow children to play with remote control. Keep remote control away from children.
6. Before installation, please check whether drive parts have good mechanical performance, balance and the action of open
and close.
7. Motor installation should be correct and reliable. Shutter should move along its rail smoothly, without any hindrances.
8. Electrical outlet should collocate earth jack and be reliably connected to the earth.
9. For installation for awnings, a horizontal distance of at least 0,4m is to be maintained between the fully unrolled driven part
and any fixed part.
10. The rated torque and operating time required must be calculated when selecting a motor for a blind, awning or shutter.
11. PVC type H05-WF cables must be installed inside the room unless they are protected by conduit or trunking which is sun
resistant.
12. When operating the motor, ensure there is no person within the area before the door or shutter closes completely.
13. All wire can’t touch the roller shutter during the installation and use of motor. Keep the receiving antenna in good
conditions. (Don’t cut the antenna short or wrap metal material around it, otherwise, it will affect the control.)
14. It will be better to install the motor in the ventilation and desiccation environment.
15. The motor should be conserved in desiccation; the battery of emitter should be replaced after the old one is used out, or
else it will affect the control distance. Change the battery as soon as the distance under the control decreases.
16. When the motor is “Up”, it is prohibited to press the “Down” directly; When the motor is “Down” , it is prohibited to press
the “Up” directly. Meanwhile the correct operation is letting motor reach limit stop to stop or pressing the “stop key”, then
the motor will make reverse turning after pressing reverse turning key.
17. Before carrying out any form of maintenance, isolate the power to the motor and controls.
18. In case you have any questions regarding the installation and the operation of the Lianda motor, or the accesories,
please call +86-572-3787832 for the consultation.
19. Lianda,declares that this product is in compliance with the essential requirements and other relevant provisions of
directive 1999/5/EC.
III. Product Type Instruction:
1.Type instruction:
Page: 1
