LI-COR LI7200RS, Инструкция по эксплуатации

Страница: 17 / 226

Analog Input and Output Cable
Part 392-10109. Used to connect external sensors to LI-7550 analog inputs; or for
analog outputs.
When used with external input devices, this cable plugs into the connector labeled
AUXILIARY INPUT
on the LI-7550 Analyzer Interface Unit connector panel. When
used for outputs, the cable plugs into the connector labeled
DAC OUTPUT
on the
LI-7550 Analyzer Interface Unit. If you intend to use both the Auxiliary Input and
DAC Output ports on the LI-7550, you will need the 7550-101 Auxiliary Sensor
Interface and an additional 392-10109 cable.
Calibration Certificate
Provides the calibration coefficients for your sensor head. These values are unique
to each sensor head and have been entered into the corresponding LI-7550 at the
factory. Keep this sheet in case you need to re-enter these values. You can also
acquire a copy of your calibration certificate from the LI-COR support web site.
The SmartFlux® 2 System
The SmartFlux 2 System comes standard
with your analyzer. It mounts inside a sys-
tems enclosure or another suitable enclos-
ure. This digital system includes a
computer that runs EddyPro
®
software for
on-site, real-time flux processing in an
eddy covariance system.
Your sonic anemometer plugs directly
into one of the three serial ports and
provides digital data and diagnostics. Gas
analyzer and biomet data is provided
through an Ethernet connection. For
more information, see the SmartFlux 2
System Instruction Manual.
Section 1. General Information
1-5 Calibration Certificate