LGMG T20J, Руководство по обслуживанию

Страница: 14 / 35

Maintenance Manual of Elevating Work Platform
8
2) Place the engine horizontally.
3)
Shut down the engine.
4)
Place the container under the engine oil
drain plug.
5)
Screw off the engine oil drain plug to drain
the old engine oil.
6) Install the new seal ring for the engine oil
drain plug and screw in and tighten it.
7)
Add engine oil at the engine oil filler.
8)
Warm up and run the engine.
9)
Place the engine horizontally.
10) Check the engine oil level and fill it if
necessary.
Use temperature Oil type
Working
temperature:-20
℃～
40
℃
CH-4/15W-40
Working
temperature:-25
℃～
30
℃
CH-4/10W-30
Working
temperature:-30
℃～
30
℃
CH-4/5W-30
Working
temperature:-35
℃～
20
℃
CH-4/0W-20
Figure 1-7
Figure 1-8
Oil filter and oil drain plug
Replacement of the Engine Oil Filter
The engine oil filter element must also be
replaced every time the engine oil is replaced.
△
! Never fill the filter in advance.
There is risk of contamination.
1)
If a torsion stopper is installed, remove the
clamping clamp (optional).
2) Release and unscrew the filter element with
a wrench.
3)
Contain the oil that was drained.
4) Clean the sealing surface of the filter holder
with a clean fiber-free wiper.
5)
Apply a thin layer of engine oil to the seal
ring of the new filter.
6)
Screw in a new filter manually until seal fit
and tighten it with 10-12 Nm.
1.9 Check for Fuel Leakage
△
!
The engine must be shut down!
No smoking and open fires!
Be careful when contacting high
temperature fuel!
Please observe the safety regulations for fuel
and relevant local regulations. Dispose of
spilled fuel and filter elements in accordance
with national regulations. The fuel cannot seep
into the ground.
Visually check for fuel leakage every 8 hours or
every day.
△
!
There is danger of explosion and
fire. The fuel of the engine is
combustible. Check the position of the
machine. When this step is performed,
the machine should be in a well-
ventilated area away from the heater,