13
EN
Removing the Bolt Assemblies
1
Starting with the bottom two transit bolts
a
, use
the spanner (included) to fully loosen all transit
bolts by turning them counterclockwise.
2
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
3
Install the hole caps.
•
Locate the hole caps
b
included in the
accessory pack or attached on the back.
Levelling the Appliance
Checking the Levelling
When pushing down the edges of the top plate
diagonally, the appliance should not move up and
down at all (check both directions). If the appliance
rocks when pushing the top plate of the appliance
diagonally, adjust the feet again.
Adjusting and Leveling the Feet
When installing the appliance, the appliance should
be aligned and perfectly level. If the appliance is not
aligned and level properly, the appliance may be
damaged or may not operate properly.
1
Turn the adjustable feet as required if the floor
is uneven.
•
Do not insert pieces of wood etc. under the
feet.
•
Make sure that all four feet should be stable
and resting on the floor.
2
Check if the appliance is perfectly level using a
spirit level
a
.
