LG TB-H488RSS5, Руководство по обслуживанию, Страница: 13 / 42

–13–
Installation of Indoor, Outdoor Unit
1. Selection of the best location
1) Indoor unit
Select location
Install the air conditioner in the location that satis-
fies the following conditions.
• Place should easily bear a load exceeding four
times the indoor unit’s weight.
• The place should enable the unit to be inspected
as shown in fig.
• The place should be such that l eveled.
• The place should allow easy water drainage.(Suit-
able dimension “H” is necessary to get a slope to
drain as figure.)
• The place should easily connect with the outdoor
unit.
• The place where the unit is not affected by an
electrical noise.
• The place where air circulation in the room will be
good .
• There should not be near the unit any heat source
or steam.
2) Outdoor unit
• If an awning is built over the unit to prevent direct
sunlight or rain exposure, be careful that heat
transfer from the condenser is not restricted.
• There should be no animals or plants in vicinity of
the hot discharged air.
• Ensure the space indicated by arrows from the
wall, ceiling, fence or other obstacles.
More than
30cm
More than
30cm
More than
70cm
Sunr
oof
Fence or
obstacles
Top view
(unit: mm)
H
Front view
450
Front
Inspection hole
(450X450)
Control box
00
01