28
USING THE PROJECTOR
Using the Keystone Function
To prevent the screen image from
becoming trapezoidal,
Keystone
adjusts
the top and bottom width of the image
if the projector is not set up at a right
angle to the screen.
Because the
Keystone
function may
cause inferior screen image quality, use
this function only when it is not possible
to set up the projector at an optimal
angle.
•Keystone 0
-
+
CLOSE
1
Press the
KEY.S
ꔌ
or
KEY.S
ꔍ
but-
ton to adjust the picture.
y
Keystone
can be adjusted
from
-40
to
40
.
2
Press the
OK
button when done.
Using the Input List
Using the Input List
1
Press the
INPUT
button to display the
input selection screen.
- The connected input mode appears
first.
Component
RGB-PC 2
RGB-PC 1
HDMI
Change Device Name
Input List
Select an input device to view.
AV
2
Select an input signal using the
remote control's
INPUT
button to
connect the projector to the desired
input. You can use the or
button to switch between all the input
modes.
Adding Input Label
Displays which devices are connected to
which input ports.
Input List
Select an input
AV
Component
RGB-PC2
RGB-PC1
HDMI
Select a device to change name.
Input Label
Close
Change Device Name
1
Press the
INPUT
button to display the
input selection screen.
2
Press the
red
button.
3
Press the or button to go to the
desired input and press the
OK
button.
4
User the , , or button to
select a device name.
