LG RN1881EZ, Руководство пользователя

Страница: 25 / 36

24 25
Installation Test (Duct check) (cont.)
Error Code Possible Causes Solutions
tE1
or
tE2
• Temperature sensor failure • Turn off the dryer and call for
service.
HS
• Humidity sensor failure. • Turn off the dryer and call for
service.
PS or PF or nP
• Electric dryer power cord is not
connected correctly, or house power
supply is incorrect.
• House fuse is blown, circuit breaker has
tripped, or power outage has occurred.
• Check the power supply or the
connection of power cord to the
terminal block. Refer to the
Connecting electric dryers
section of this manual
for complete instructions.
• Reset circuit breaker or replace fuse. Do not increase
the fuse capacity.
If the problem is a circuit overload, have it corrected
by a qualified electrician.
Restricted or blocked airflow
Avoid long runs or runs with multiple elbows or
bends.
Excess or crushed
transition duct
Too many elbows or
exhaust too long
Check for blockages and lint buildup.
Make sure the ductwork is not crushed or restricted.
Crushed or
damaged
exhaust
Lint buildup
or blockage
inStaLLation inStructionS
HOW TO USE
Operating the Dryer
Turn On the Dryer
Press the POWER button to turn on the dryer. The cycle LEDs will illuminate
and a signal will sound, if turned on. Refer to page 10.
3
G F A
D E B C
G F A
D E B C
G F A
D E B C
Begin the cycle
Press the START/PAUSE button to begin the cycle. The cycle can be paused at
any time either by opening the door or by pressing the START/PAUSE button. If
the cycle is not restarted within 4 minutes, the dryer will shut off and the cycle
settings will be lost.
5
Select a Cycle
Press the Cycle buttons until the indicator for the desired cycle is lit.
The preset temperature, dry level, and option settings for that cycle will be
shown. Default settings for the selected cycle can now be changed if desired.
Refer to the Cycle Setting and Options page for details.
4
End of Cycle
When the cycle is finished, the chime will sound if it is set. Remove your
clothing from the dryer immediately to reduce wrinkling. If Wrinkle Care is
selected, the dryer will tumble briefly every few minutes to help prevent
wrinkles from setting in the clothes.
6
G F A
D E B C
Clean the Lint Filter
If the lint filter has not already been cleaned, lift out the filter and remove the
lint from the last load. This will help ensure the fastest and most efficient drying
performance.
1
Load the Dryer
Load the dryer with the wet laundry from the washer. If the load is extra large,
you may need to divide it into smaller loads for proper performance and fabric
care.
2
Lint
Filter
notE
Not all options or modifiers are available on all cycles. Refer to the Cycle
Guide page for default settings and allowable options. A different chime will
sound and the LED will not come on if the selection is not allowed.
HoW to uSE