16
206-4342
EZ-Manager Wizard (Cont.)
(Continued from previous page)
Note:
The TV Zoning feature is only applicable for TVs that will be configured using a “.tlx” file (local
or remote
configuration). Also, this feature is only available when Installer Menu item 027 HOSPITAL
MODE is set to 0 (i.e., Hospital Mode is disabled). See also item 027 description on page 41.
1. Complete the appropriate field(s) as described below.
Use the Left/Right arrow keys on the
Installer Remote to navigate between each of the fields.
•
Zone: Enables you to set a TV Zone # so that the TV can be configured with Installer Menu
and/or Setup Menu settings intended only for the assigned Zone. The Installer Menu and/
or Setup Menu settings may be provided in a
Clone/Configuration (.tlx) file
. If the TV is being
configured for FTG Mode via CPU, the TV Zone # setting also allows the TV to omit channels
that have been restricted in the FTG Channel Map.
To change the TV Zone from its default value (0), navigate to the
Zone field at the left of the
screen, and use the Up/Down arrow keys to specify the desired TV Zone # (1–8).
• Label: Allows you to select a North, South, East, or West text label for this TV. In the Label
field, use the Up/Down arrow keys to select the applicable label.
• Room Number: Allows you to specify the number of the room—up to 16 characters—in which
the TV is located. In the Room Number field, you can use the number keys on the Installer
Remote to direct enter a room number. Use the Dash key on the Installer Remote as necessary
to toggle between number and letter characters in the Room Number field. Also, you can use
the Flashback key on the Installer Remote to delete characters in this field.
2. When you are ready to continue, select the appropriate option, as follows:
• To proceed to the next EZ-Manager screen, use the arrow keys to select
Next
, and then press
OK
on the Installer Remote
. Continue to “Configure Pro:Centric Settings” below.
•
To use a USB memory device to complete the configuration, select
USB Configuration
. See
“
19 to 21 for further information.
Configure Pro:Centric Settings
Once you select “Next” from the TV Configuration Options screen, the Searching for Pro:Centric
Server screen is displayed.
Note:
Select the “Back” button, where available, to check previous settings, as necessary. Also
note that if any of the configuration steps fails, you will see a “Diagnostics” screen with an indication
of the failure. You will then have the opportunity to reinitiate the configuration process from the
previous screen or exit the EZ-Manager Wizard.
Z
EZ-Manager Wizard
Back
Manual Pro:Centric
4
3
2
1
Searching for Pro:Centric Server...
Exit
It may take 1 min 32 second(s).
This step automatically searches for the Pro:Centric server.
If there is no Pro:Centric Server installed, you do not need to continue
with this procedure. Please select either ‘Exit’ or ‘Manual Pro:Centric’.
Status : Tuning channel 49
TV is now searching all of the channels for the data channel...
(Continued on next page)