17
INSTALLATION
ENGLISH
Assembling the Refrigerator Door
1
Place the door onto the lower hinge pin.
Lower Hinge
2
Fit the upper hinge over the hinge lever latch and
into place. Rotate the lever counterclockwise to
secure the hinge.
(1)
(2)
3
Reconnect all wire harnesses. Hook the tab on
the switch side of the cover under the edge of the
wire opening in the cabinet top. Position the cover
and replace the screw.
Connecting the Water Line
Before Beginning
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
hammer before installing the water supply line to
the refrigerator. Water banging in the pipes, or water
hammer in residential plumbing can cause damage
to refrigerator parts and lead to water leakage or
•
Turn the icemaker OFF if the refrigerator will be
used before the water line is connected.
•
Do not install the icemaker tubing in areas where
the ambient temperatures fall below freezing.
WARNING
•
Connect to a potable water supply only.
CAUTION
•
To prevent burns and product damage, only
connect the refrigerator water line to a cold water
supply.
•
Wear eye protection during installation toprevent
injury.
Water Pressure
You will need a cold water supply.
Water Pressure
20–120 psi
(138 - 827 kPa)
where reverse osmosis
connected to a cold water
supply
40–60 psi minimum to
reverse osmosis system
(2.8 kgf/cm
2
– 4.2 kgf/
cm
2
,or less than 2–3
oz capacity)
Содержание LS64SXP
Страница 50: ...50 NOTES ENGLISH ENGLISH ...
Страница 51: ...51 NOTES ENGLISH ...