
Electronics
AC Module System Installation Manual
Copyright © 2020 LG Electronics.
All Rights Reserved.
81
Rev. 1.0
5-2 Replacing an EnerBox2
First, physically install the new Enerbox2 using the following procedure:
1. Unplug the power cord of the old EnerBox2
2. Place the new EnerBox2 at the same location. Connect the power cord to the new EnerBox2
and a power outlet (same outlet used by the old EnerBox2).
3. Enable the installed EnerBox2 access to the Internet in reference of the AC Module System
Installation Manual where 4-3 installing EnerBox2 describes Step 2.
Since you are transferring the information from the Web server to the new EnerBox2, you
need to connect to the Internet to use the ‘Replace’ function.
•
Using EnerVu2’s website
Select for [ System -> Activated System -> Select the system -> Manage ->
EnerBox Info -> View Detail].
As before, you can find the ‘Replace’ button by pressing EnerBox2 S/N in the left System View
or by clicking ‘View Detail’ in the EnerBox Info.
When you press the ‘Replace’ button, the above pop-up window will appear. Enter the newly installed
EnerBox2 S/N. Verify it with the ‘Check’ button, and click ‘Replace’ at the bottom right in order to perform
communication between EnerBox2 and the Web server.
Replace function should be performed after physical installation in steps 1 - 3 above. If the newly
installed EnerBox2 does not connect to the Internet, the Replace function cannot be executed
because the EnerBox2 S/N verification has not been made.