LG L14, Руководство пользователя

Страница: 26 / 41

26
ENG
ENGLISH
PICTURE ID
Picture ID is used to change the settings of a specific
display using a single IR receiver for multi-vision. The
set receiving the IR signal communicates with another
set via an RS-232C connection. Each set is identified by
a Set ID. If you assign the Picture ID using the remote
control, only displays with the same Picture ID and Set
ID can be controlled remotely.
1
Press the red
ON
button on the remote control to
assign the Picture ID.
2
To change the Picture ID, press the
ON
button,
or the left and right arrow buttons continuously.
Assign the ID you want.
y y
If you assign the Set ID to each set with multi-
vision, and then assign the Picture ID using
the red button on the remote control, the key
command is displayed for the set with the same
Set ID and Picture ID. A set with different Set
IDs and Picture IDs cannot be controlled by IR
signals.
y y
For example, if the Picture ID is assigned to
2, the upper right display (Set ID: 2) can be
controlled by IR signals.
y y
For each set, you can change the settings for
the PICTURE, TIME, NETWORK and MY MEDIA
menus or the hot keys on the remote control.
y y
If you press the green
OFF
button for Picture
IDs, the Picture IDs for all sets are turned off.
If you then press any button on the remote
control, all sets will start working again.
y y
Picture ID will be disabled while using the MY
MEDIA menu.
y y
If Picture ID is set to Off, holding buttons on the
remote control will execute only one action at a
time.
NOTE
2X2 Multi-Vision
Set IDs are assigned as shown in the picture.
IR Receiver
AUDIO
(RGB/DVI)
REMOTE
CONTROL IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
RS-232C OUT
RS-232C IN
Picture ID
Close
Off
RS-232C