60
206-4307
IP Environment Setup (Cont.)
*
PCS150R and later Pro:Centric servers do not support HRC or IRC cable channel frequencies.
Pro:Centric Setup
Pro:Centric options enable you to configure the TV with the appropriate
settings to connect to the Pro:Centric server. Use the Up/Down arrow
keys on the Installer Remote to navigate between fields.
1. With the IP Environment Menu on display, use the arrow keys on
the Installer Remote to select the
Pro:Centric
menu option. Then,
press the Wheel (
OK
) button.
2. Select/highlight the
Media Type
field and press
the Wheel (
OK
)
button on the Installer Remote to display the drop-down list of
options. Then use the Up/Down arrow keys to select either
RF
or
IP
, as applicable.
Note:
If the Media Type has already been set in the EZ-Manager
Wizard, the specified value will be reflected in this field.
3. Refer to the appropriate subsection(s) below to configure the TV’s
Pro:Centric settings to match those of the Pro:Centric server.
While the Pro:Centric application itself is an additional feature
(see step 4), the appropriate Pro:Centric server configuration
must be completed to enable TV E-Z Installation (configuration
and software/firmware) data downloads and, if configured, the
Pro:Centric application download.
RF Configuration
For TVs in Pass-through Mode or FTG Mode, if the Data Channel is left
at its default value (AUTO), the TV’s Data Channel Auto Search feature
will be enabled. See Installer Menu item 119 DATA CHANNEL description
on page 39 for further information.
To change the Data Channel setting, select/highlight the
Data Channel
field
and press the Wheel (
OK
) button on the Installer Remote. Then, use the Up/
Down arrow keys to select either
MANUAL
or
AUTO
from the drop-down list
of options.
When the Data Channel field is set to “
MANUAL
,” a data entry field is available
on the screen, and you can specify the RF channel number that will be used
by the Pro:Centric server as its data channel. The Data Channel value can
be set from 0 (disabled) to 135.
* Use the arrow keys on the Installer Remote
to s
elect the Data Channel data entry field and press
the Wheel (
OK
) button.
You can then use the number keys on the Installer Remote to direct enter the
Data Channel, or you can use the arrow keys to select the appropriate
number(s) from the pop-up virtual keyboard displayed at the bottom of the
screen. When you are done, select
Enter
from the virtual keyboard, and then
press the Wheel (
OK
) button on the Installer Remote.
Note:
If the Data Channel has already been set in the Installer Menu (Installer
Menu item 119) or in the EZ-Manager Wizard, the specified channel will appear
in the Data Channel data entry
field. If you change the Data Channel in this
menu, Installer Menu item 119 will now show the value you entered here.
(Continued on next page)
Network
Pro:Centric
Media Share
Pre-loaded
Apps
PRO:CENTRIC
Mode
Configuration Only
Update Event
Disable
Media Type
RF
Data Channel
AUTO
^
^
^
^
Note:
By default, the Pro:Centric Menu
initially shows RF configuration fields.
When “IP” is selected as the Media Type,
Server Address and either IP Address
and Port Number or Domain Name and
Port Number fields appear on the screen
(in place of the Data Channel field).
