50
206-4309
Cloning Procedures (Cont.)
(Continued from previous page)
12. When you are ready to continue, select
UPDATE
on the screen and then press
OK
on the
Installer Remote.
Import progress will be displayed on the screen. This process may take a few minutes. Do
NOT remove the USB device while importing is in progress. When the import process is
complete, an IMPORT COMPLETE pop-up banner will briefly be displayed at the bottom of
the screen, and then, the TV will reboot.
13. Remove the USB memory device from the Target TV, and verify that the appropriate
configuration is now resident on the Target TV.
Note:
If the Target TV was previously in Pass-through Mode, and the
Clone/Configuration (.tlx)
file that was imported contained an FTG Channel Map, the Target TV CPU is now in FTG Mode.
Upon restart, the TV tunes according to the Start Channel setting in the Installer Menu. If a Start
Channel is specified, the
TV will tune to that channel, though, in the case of FTG Mode via CPU
configuration, a channel banner will only be displayed if the Start Channel is included in the FTG
Channel Map (depending on your selection in step 11, the channel banner will display either the
Start Channel’s logical channel number or physical RF channel number). Otherwise, the TV will
either return to the last channel tuned (TV in Pass-through Mode) or tune to the first channel in the
FTG Channel Map (TV in FTG Mode via CPU). If the latter, remember that the channels in the FTG
Channel Map are always arranged in logical order, regardless of your selection in step 11.
