12
INSTALLATION
Unpacking and Removing
Shipping Bolts
1
Lift the washer off the foam base.
After removing the carton and shipping material,
lift the washer off the foam base. Make sure the
plastic tub support comes off with the base and
is not stuck to the bottom of the washer.
If you must lay the washer down to remove the
base packaging materials, always protect the
side of the washer and lay it carefully on its side.
Do not lay the washer on its front or back.
Foam tub
support
Carton base
2
Remove the bolt assemblies.
Starting with the bottom two shipping bolts, use
the wrench (included) to fully loosen all four
shipping bolts by turning them counterclockwise.
Remove the bolt assemblies by wiggling them
slightly while pulling them out.
Retainer
Shipping
bolt
3
Install the hole caps.
Locate the four hole caps included in the
accessory pack and install them in the shipping
bolt holes.
Cap
NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, do not transport
the washer without reinstalling the shipping bolts.
• Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead
to permanent damage to the washer. The cord is
secured to the back of the washer with a shipping
bolt to help prevent operation with shipping bolts in
place.
Содержание WM9500H*A
Страница 53: ...53 MEMO ...
Страница 54: ...54 MEMO ...
Страница 107: ...53 MEMO ...
Страница 108: ...For inquires or comments visit www lg com or call 1 800 984 6306 USA ...