37
EN
Delay Wash( )
You can set a time delay so that the washing
machine will start automatically and finish after
the set specified time interval.
1
Press the
Power
button.
2
Select a washing programme.
3
Press
Delay Wash
(
) under the
programme.
4
When you want to change the time, touch
the display.
5
Set
Est. End Time
.
6
Press the
OK
button.
NOTE
•
The delay time is the time up until the
end of the programme, not the start. The
actual running time may vary due to water
temperature, wash load and other factors.
•
When the
Delay Wash
has been set, the
remaining time appears on the display.
•
The delay time can be set up to 24 hours
from now and cannot be set if it is within the
minimum hours of a wash programme.
•
To cancel the Delay Wash function, the
Power
button should be pressed.
Add Item
Laundry can be added or removed after the
washing programme is started.
1
Press the
Start/Pause
button.
2
Press the
Add Item
.
3
Open the door after door lock is released.
4
Add or remove laundry.
5
Press the
Start/Pause
button again to
continue the cycle. The cycle continues
automatically.
NOTE
•
For safety reasons, the door remains locked
when the water level or temperature is high. It
is not possible to add laundry during this time.
•
If the water temperature in the drum is high,
wait until it cools down.
CAUTION
•
When adding laundry, make sure to
completely push it into the drum. If laundry
gets stuck in the door latch hole, the rubber
door seal may be damaged, causing water
leakage and malfunction.
•
Forcing the door open may cause serious
damage, malfunction, or safety hazards.
•
If you open the door while there is a lot of suds
and water in the drum, the suds or water may
flow, causing scalding injury or damage to the
floor by wetting it.
Содержание WD1610NSW
