LG SIGNATURE WD1610NSW, Руководство пользователя

Страница: 19 / 64

19
EN
3
Push the adapter onto the end of the tap
so that the rubber seal forms a watertight
connection. Tighten the four fixing screws
and the adapter ring plate.
4
Pull the connector latch plate down, push the
supply hose onto the adapter, and release
the connector latch plate. Make sure the
adapter locks into place.
Latch plate
NOTE
•
After connecting the supply hose to the water
tap, turn on the water tap to flush out foreign
substances (dirt, sand, sawdust, and etc.)
in the water lines. Let the water drain into a
bucket, and check the water temperature.
Connecting Hose to Appliance
Attach the hot water line to the hot water inlet
on the back of the washer. Attach the cold water
line to the cold water inlet on the back of the
washer. Connect the curved end of the water
hose connector to the washer.
Cold
water
supply
Hot water
supply
(optional)
NOTE
•
After completing connection, if water leaks
from the hose, repeat the same steps. Use
the most conventional type of tap for the water
supply. In case the tap is square or too big,
remove the guide plate before inserting the tap
into the adaptor.
Using the Horizontal Tap
Horizontal tap
Extension tap
Square tap