17
EN
Using the Drain Hose Connector
1
Connect the drain hose of Main Washer and
Mini Washer to the drain connector.
2
Insert the included wire hose clamps on to
the ends of the two drain hoses.
3
Push the drain hoses firmly onto the drain
connector.
Drain hose
connector
CAUTION
•
Adjust the wire hose clamps to prevent the
hoses from coming loose or leaking. Failure to
do so could result in flooding. Use of the drain
connector helps avoid siphoning, odors, or
improper draining.
•
Make sure the drain hose is not kinked or
pinched. This is a potential cause of drainage
problems or noise.
NOTE
•
Depending on the installation environment, you
may have to purchase a separate drain hose
connector.
Leveling the Appliance
If the floor is uneven, turn the adjustable feet as
required (Do not insert pieces of wood etc. under
the feet). Make sure that all four feet are stable
and resting on the floor and then check that the
appliance is perfectly level (Use a spirit level).
•
Once the appliance is level, tighten the lock
nuts up towards the base of the appliance. All
lock nuts must be tightened.
Raise
Lower
Lock nut
Tighten all 4
lock nuts securely
Diagonal Check
•
When pushing down the edges of the top plate
diagonally, the appliance should not move up
and down at all (check both directions). If the
appliance rocks when pushing the machine top
plate diagonally, adjust the feet again.
WARNING
•
When stacking Main Washer on Mini Washer,
use the leveling feet on Mini Washer to level
both. Main Washer´s leveling feet should be
minimized and the locknuts turned counter-
clockwise to secure them.
NOTE
•
Timber or suspended type flooring may
contribute to excessive vibration and
unbalance.
•
If Mini Washer is installed on a raised platform,
it must be securely fastened in order to
eliminate the risk of falling off.
