MODEL
RNDF-BP02A
Please read this manual carefully before operating
your set and retain it for future reference.
Network Camera
INSTALLATION MANUAL
Specification
RNDF-BP02A
Camera
Image Device
1/3" Progressive Scan CMOS
Lens Type
2.8-12mm Vari-Focal Lens
Day / Night
ICR
Minimum illumination
Color : 0.6Lux @(F1.2,AGC ON)
B/W : 0 Lux with IR LED on
IR Distance
20m
Image Enhance
Backlight compensation, Saturation, Brightness,
Contrast, Sharpness, White balance, Exposure, Flip or
Rotate Mode, Corridor, Privacy mask
Video /
Audio
Compression
H.265 / H.264 / MJPEG
Resolutions
3MP(2048*1536), 1296P(2304*1296), 1080P,
960P, 720P(1280*720)
Maximum Frame rate
60Hz : 30fps @ 3MP, 1296P, 1080P, 960P, 720P
50Hz : 25fps @ 3MP, 1296P, 1080P, 960P, 720P
Multi-Streaming
Up to 3
ROI (Smart-Codec)
Support (Up to 8 zones)
Video Analytics
Perimeter, Line Crossing, Stationary Object, Face
Detection, Cross Counting
Text Overlay
Support
Audio Compression
G711A, G711U, ADPCM, G726
2-way Audio
Support
Event
Event Trigger
Motion Detection, Port Alarm
Event Notification
Relay Out, Email, FTP
Pre-Alarm Recording
Support
Interface
Analog Out
1 BNC Out
Audio In / Out
1 In / 1 Out
Alarm In / Out
1 In / 1 Out
SD Slot
Micro SD (Up to 128GB)
Network
Ethernet
RJ-45 10, 100 BASE-T
Security
Password protection, IP Filter
Open Protocol
ONVIF
Protocol
TCP/IP, UDP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS,
RTP, RTSP, RTCP, PPPoE, NTP, UPnP, SMTP, SNMP, IGMP,
802.1X, QoS, IPv6, Bonjour
Integrated Software
Mobile Application(iPhone, iPad, Android)
Connections
Max. 10
General
Power Source
DC 12V, PoE
Maximum Power
Consumption
5W (DC 12V), 6W (PoE 48V)
Maximum Input Current
417mA (DC 12V), 125mA (PoE)
Operating conditions
-10°C ~ 60°C 0% RH to 95% RH
Protection
IP66, IK10
Dimensions
146.9 x 146.9 x 112.5 mm
Weight
844 g
Note that design and specification of this unit may change from the manual as quality and
improvement without prior notice.
Open Source Notice Information
To obtain the source code under GPL, LGPL, MPL and other open source licenses, that is contained
in this product, please visit http://secu-iot.lginnotek.com.
In addition to the source code, all referred license terms, warranty disclaimers and copyright notices
are available for download.
*5PKA00129L*
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER (OR BACK)
NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning flash with arrowhead symbol within an equilateral triangle is
intended to alert the user to the presence of uninsulated dangerous voltage
within the product’s enclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle is intended to alert the
user to the presence of important operating and maintenance (servicing)
instructions in the literature accompanying the product.
WARNING:
TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO NOT EXPOSE THIS PRODUCT
TO RAIN OR MOISTURE.
WARNING:
Do not ins tall this equipment in a confined space such as a book case or similar unit.
CAUTION:
The apparatus should not be exposed to water (dripping or splashing) and no objects
filled with liquids, such as vases, should be placed on the apparatus.
CAUTION:
Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of
the product and to protect it from over heating. The openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar surface. This product shall not be placed in a built-in
installation such as a bookcase or rack unless proper ventilation is provided or the manufacturer’s
instruction has been adhered to.
CAUTION:
Do not use high voltage products around this product. (ex. Electrical swatter) This
product may malfunction due to electrical shock.
CAUTION:
No naked flame sources, such as lighted candles, should be placed on the apparatus.
WARNING:
Wiring methods shall be in accordance with the National Electric Code, ANSI/NFPA
70.
WARNING:
This is a class A product. In a domestic environment this product may cause radio
interference in which case the user may be required to take adequate measures.
WARNING:
To reduce a risk of fire or electric shock, do not expose this product to rain or
moisture.
WARNING:
The product has been dropped or the case is broken, turn off the power and unplug
the power cord. (This may cause fire, electric shock, or injury.)
WARNING:
If the product has no video out or sound, please stop using. Unplug the power cable
immediately and contact the service center. (This may cause fire or electric shock.)
CAUTION:
This installation should be made by a qualified service person and should conform to
all local codes.
CAUTION:
To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel
only.
CAUTION:
Prevent the power cable from being severely bent or having pressure exerted on it by
a heavy object.
CAUTION:
It is permitted to use ancillary equipment (e.g. A UPS) to prevent the damage from
mains supply voltage reductions.
CAUTION:
The power plug is the disconnecting device. In case of an emergency, the Power Plug
must remain readily accessible.
NOTICE:
For safety marking information including product identification and supply ratings, please
refer to the main label on the bottom or the other surface of the product.
Disposal of your old appliance
1. This crossed-out wheeled bin symbol indicates that waste electrical and
electronic products (WEEE) should be disposed of separately from the
municipal waste stream.
2. Old electrical products can contain hazardous substances so correct
disposal of your old appliance will help prevent potential negative
consequences for the environment and human health. Your old appliance
may contain reusable parts that could be used to repair other products, and
other valuable materials that can be recycled to conserve limited resources.
3. You can take your appliance either to the shop where you purchased
the product, or contact your local government waste office for details of
your nearest authorised WEEE collection point. For the most up to date
information for your country please see www.lg.com/global/recycling
NOTE:
Please make sure the product is installed appropriate places where secured from flood, such as
under the eaves, to operate properly. This product is certified as IP66 standard. However, if there
is any flood concerns, it is highly recommended to use an outdoor Housing When you install the
camera inside an outdoor Housing, please use one of the following methods:
1. Remove the front glass of Housing before installing the camera.
2. To keep the front glass of Housing, remove the front cover, and then put the camera close to
the front glass.
Power Supply
This camera must always be operated DC 12 V Certified/Listed Adaptor which comply with LPS.
Handling of the unit
Be careful not to spill water or other liquids on the unit. Be cautions not to get combustible or
metallic material inside the body. If used with foreign matter inside, the camera is liable to fail or to
get cause of fire or electric shock.
•
Remove dust or dirt on the surface of the lens with a blower.
•
Use a dry soft cloth to clean the body. If it is very dirty, use a cloth dampened with a small
quantity of neutral detergent then wipe dry.
•
Avoid the use of volatile solvents such as thinners, alcohol, benzene and insecticides. They may
damage the surface finish and/or impair the operation of the camera.
•
This camera is designed for mounting on the ceiling or wall. If you install this camera upside
down, it may cause malfunction.
Operating and storage location
Avoid viewing a very bright object (such as light fittings) during an extended period. Avoid
operating or storing the unit in the following locations.
•
Extremely hot or cold places (operating temperature -10 °C to 60 °C, however, we
recommend that the unit be used within a temperature range of 0 °C to 45 °C)
•
Damp or dust place
•
Places exposed to rain
•
Places subject to strong vibration
•
Close to generators of powerful electromagnetic radiation such as radio or TV
transmitters.
Symbols
~
Refers to alternating current(AC).
0
Refers to direct current(DC).
Refers to class II equipment.
1
Refers to stand-by.
!
Refers to “ON” (power).
Refers to dangerous voltage.
Components
Camera
Template Label
Wrench
Tapping Screws (4EA)
Installation Manual
Anchor (4EA)
Water-proof Connector
Rubber fitting and Rubber Ring
