Lexus CT 200H 2016, Руководство пользователя

Страница: 117 / 632

CT200h_OM_OM76197U_(U)
117
3-2. Opening, closing and locking the doors
3
Op
era
tio
n of
ea
ch
co
m
po
ne
nt
●
If the electronic key is inside the vehicle and a door handle becomes wet during a car
wash, a message may be shown on the multi-information display and a buzzer will
sound outside the vehicle. To turn off the alarm, lock all the doors.
●
The lock sensor may not work properly if it comes into contact with ice, snow, mud, etc.
Clean the lock sensor and attempt to operate it again, or use the lock sensor on the
lower part of the door handle.
●
A sudden approach to the effective range or door handle may prevent the doors from
being unlocked. In this case, return the door handle to the original position and check
that the doors unlock before pulling the door handle again.
●
If there is another electronic key in the detection area, it may take slightly longer to
unlock the doors after the door handle is gripped.
●
Fingernails may scrape against the door during operation of the door handle. Be care-
ful not to injure fingernails or damage the surface of the door.
■
When the vehicle is not driven for extended periods
●
To prevent theft of the vehicle, do not leave the electronic key within 6 ft. (2 m) of the
vehicle.
●
The smart access system with push-button start can be deactivated in advance.
(

P. 591)
■
To operate the system properly
Make sure to carry the electronic key when operating the system. Do not get the elec-
tronic key too close to the vehicle when operating the system from the outside of the
vehicle.
Depending on the position and holding condition of the electronic key, the key may not
be detected correctly and the system may not operate properly. (The alarm may go off
accidentally, or the door lock prevention may not operate.)
■
If the smart access system with push-button start does not operate properly
●
Locking and unlocking the doors: Use the mechanical key. (

P. 560)
●
Starting the hybrid system:

P. 561
■
Customization
Settings (e.g. smart access system with push-button start) can be changed.
(Customizable features:

P. 591)
■
If the smart access system with push-button start has been deactivated in a customized
setting
●
Locking and unlocking the doors:
Use the wireless remote control or mechanical key. (

P. 105, 560)
●
Starting the hybrid system and changing power switch modes:

P. 561
●
Stopping the hybrid system:

P. 157