Lexmark XM9100 Series, Руководство пользователя

Страница: 130 / 364

Use To
NPA Mode
Off
Auto
Set the printer to perform the special processing required for bidirectional
communication following the conventions defined by the NPA protocol.
Notes:
• Auto is the factory default setting.
•
The printer automatically restarts when the setting is changed from the
control panel.
Network Buffer
Auto
3KB to [maximum size allowed]
Set the size of the network input buffer.
Notes:
•
Auto is the factory default setting.
• The maximum size allowed depends on the amount of memory in the printer,
the size of the other link buffers, and whether Resource Save is set to On or
Off.
•
To increase the maximum size range for the Network Buffer, disable or
reduce the size of the parallel, serial, and USB buffers.
•
The printer automatically restarts when the setting is changed from the
control panel.
Job Buffering
Off
On
Auto
Temporarily store print jobs in the printer hard disk before printing. This menu only
appears when a formatted disk is installed.
Notes:
•
Off is the factory default setting.
• The printer automatically restarts when the setting is changed from the
control panel. The menu selection is then updated.
Mac Binary PS
On
Off
Auto
Set the printer to process Macintosh binary PostScript print jobs.
Note: Auto is the factory default setting.
Standard Network Setup OR
Network [x] Setup
Reports
Network Card
TCP/IP
IPv6
Wireless
AppleTalk
Show and set the printer network settings.
Note: The Wireless menu appears only when the printer is connected to a wireless
network.
Reports menu
To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > Reports
•
Network/Ports > Network [x] > Network [x] Setup > Reports
Understanding the printer menus 130