Lexmark Pro5500 Series, Руководство по обслуживанию

Страница: 68 / 277

2-25
Service Manual
4447-20x
Go Back
Previous
Next
Copy skew
Step Questions / actions Yes No
1 Turn off the printer by unplugging the power cord. Wait
for 10 seconds, and turn on the printer. Run the copy job
again.
Does the problem remain?
Go to step 2. Problem
resolved
2 Are you running the copy job from the ADF? Go to step 3. Go to step 8.
3
Check the copy setting. Set the paper settings according
to the type and size of the original document.
Does the problem remain?
Go to step 4. Problem
resolved
4
Check if the paper guides of the ADF input tray are
properly set. Move the paper guides to the center, and
check if the distance to the center is equal for both paper
guides.
Are the paper guides free from any damage?
Go to step 5. Go to step 13.
5
Check if the ADF pick assembly and separation pad are
not worn out and contaminated.
Are the ADF pick assembly and separation pad worn
out and contaminated?
Go to step 14. Go to step 6.
6 Check if the ADF door is properly installed. Check if the
ADF paper path rollers are not contaminated.
Is the ADF door free from damage?
Go to step 7. Go to step 15.
7 Check for any obstruction on the paper path.
Is the paper path free from any obstruction?
Go to step 11. Clear the
obstruction.
8
Check for any stain, dirt, or obstruction in the scan area
on the flatbed glass plate.
Check for any obstruction on the alignment edge of the
flatbed scanner.
Clean the scanner glass with a piece of cloth. Clear the
scan area from any stain, dirt and obstruction.
Does the problem remain?
Go to step 9. Problem
resolved
9 Check if the flatbed scan bar is seated properly on the
scan bar carriage unit. Check the scan bar belt for any
damage.
Is the scan bar free from damage?
Go to 10. Go to step 17.
10 Check if the flatbed scan bar can find its base position
during POST sequence.
Can the flatbed scan bar find its base position?
Go to step 11. Go to step 17.