Lexmark Pro5500 Series, Руководство по обслуживанию

Страница: 149 / 277

Diagnostic aids
3-12
4447-20x
Go Back
Previous
Next
Single Test Page
Selecting Single Test Page will cause the printer to gather data for printing the generated test page. The test
page will be the Lexmark manufacturing page which is targeted for development. This test page will contain text
only, no ramps or purge bars are printed. It contains the following information:
•
Code version
•
Date of Release
•
Page Count
•
Maintenance: On/Off
•
Thermal Control: On/Off
•
PH Short Test: On/Off
•
PH Bar Code
•
Ink Tank Status:
–
Black: In/Out
–
Cyan: In/Out
–
Magenta: In/Out
–
Yellow: In/Out
•
Security Fuses Set: Yes/No
•
Watchdog: On/Off
•
PH ETEST – previously performed? Yes/No
•
Real Time Ambient
•
Ambient at Calibration
•
ADC count for each zone at calibration
•
Slope correction factor
•
RT Temp for each zone
•
DDR Tune Min, Max, Chose Value (for both DDRs)
•
DRO (digital ring osc): “fast”/”slow”
•
Auto Alignment LED duty cycle
–
Red LED:
–
Blue LED:
•
Manufacturing Mode Status: Yes/No
•
USB Serial Number: Enabled/Disabled
•
USB Vendor ID
•
Device ID fields (1284 ID, inc MFG, CMD, Model, Class, DES):
•
Mode Table for fire pulses, target temps vs media
•
Media Sense
–
Low Cal (C0)
–
High Cal (C1)
–
Calibrated (Yes/No)
To print the Single Test Page, from the Manufacturing Test menu, navigate to Single Test Page .
Manufacturing Mode
This option activates the Manufacturing Mode. The default setting is Off.
To change this setting:
1.
From Manufacturing Test, navigate to Manufacturing Mode .
2.
Select ON or OFF .
•
Selecting ON will bring the printer up in Manufacturing Mode after the next POR.
•
Selecting OFF will bring the printer up in User Mode after the next POR.
3.
Touch to save the setting, or touch to return to the Manufacturing Test menu without saving
any changes.