30
Verify the setup
Make a test copy
Copy mode is the default setting of the control panel.
1
Make sure the
Ready
status message is displayed.
2
Place your original in the scan unit.
3
Press Go/Send to send a copy to your printer.
See “Solve setup problems” on page 31 if the printer does not print a copy.
Send a test fax
Send a one page test fax to someone and ask for feedback.
Press Stop/Clear to stop a fax
from being sent or cancel a fax
that is already being sent. The
control panel resets to copy
mode.
1
Press Fax/Scan Mode repeatedly until the
Enter Number
prompt appears.
2
Use the numeric keypad on the control panel and enter the phone number
of the person receiving the fax.
3
Place your original in the scan unit.
4
Press Go/Send to send a fax.
Test your scan functions
Test your scan to network functions by creating Scan Profiles or scanning to
permanent destinations. Detailed instructions for using the scan to network
functions can be found in “Chapter 4: Network Scanning” on page 53.
Important:
You can only test the scan to network functions that you added
during setup. For example, to test Scan to e-mail function, you must
have created at least one permanent e-mail destination. Otherwise,
Scan
→
does not appear as a scan to network mode in the
OptraImage control panel.
14
