Lexmark MB2236, Руководство по обслуживанию

Страница: 227 / 317

Removal procedures
Keep the following tips in mind as you replace parts:
•
Some removal procedures require removing cable ties. You must replace cable ties during reassembly to
avoid pinching wires, obstructing the paper path, or restricting mechanical movement.
•
Remove the toner cartridges, imaging kit, and trays before removing other printer parts. The imaging kit
must be carefully set on a clean, smooth, and flat surface. It must also be protected from light while out of
the printer.
•
Disconnect all external cables from the printer to prevent possible damage during service.
•
Unless otherwise stated, reinstall the parts in reverse order of removal.
•
When reinstalling a part held with several screws, start all screws before the final tightening.
•
For printers that have a soft power switch, make sure to unplug the power cord after powering off.
Left side removals
Left cover removal
1
Remove the tray insert.
2
Remove the duplex unit.
3
Remove the rear door. See “Rear door removal” on page 243 .
4
Remove the bottom rear door. See “Bottom rear door removal” on page 244 .
5
Remove the left cover.
3400-48x
Parts removal
227