Printer shows error 58 or input configuration error
Error 58 indicates that the RFID option has been installed in a wrong position. A problem in the RFID option or
media tray may also result in error 58.
Try one or more of the following:
Make sure that the RFID option is installed correctly
The RFID option must be installed below the standard 550
‑
sheet tray and above the media tray. For more
information, see
“Installing the RFID option” on page 9
Make sure that the number of trays installed below the RFID option is correct
•
Lexmark CS725R printer supports up to three media trays.
•
Lexmark CX725R MFP supports up to two media trays.
Replace either the media tray or the RFID option
1
Check the cause of the error. Do the following:
a
Remove the media trays from the printer.
b
Without unplugging the RFID option USB cable from the printer, remove the RFID option.
c
Install the RFID option, and then install the media tray.
2
If the error persists after installing the RFID option, then replace the RFID option.
3
If the error persists after installing the media tray, then replace the media tray.
Contact your Lexmark representative
Troubleshooting
31
