Lexmark C2132, Руководство пользователя

Страница: 55 / 226

Weight
The printer trays can automatically feed paper weights up to 176
‑
g/m
2
(47
‑
lb) bond grain long paper. The
multipurpose feeder can automatically feed paper weights up to 176
‑
g/m
2
(47
‑
lb) bond grain long paper. Paper
lighter than 60 g/m
2
(16 lb) might not be stiff enough to feed properly, causing jams. For best performance, use
75
‑
g/m
2
(20
‑
lb) bond grain long paper. For paper smaller than 182 x 257 mm (7.2 x 10.1 inches), we recommend
90 g/m
2
(24 lb) or heavier paper.
Note: Duplex printing is supported from 60–105
‑
g/m
2
(16–28
‑
lb) bond grain long paper.
Curl
Curl is the tendency for paper to curl at its edges. Excessive curl can cause paper feeding problems. Curl can
occur after the paper passes through the printer, where it is exposed to high temperatures. Storing paper
unwrapped in hot, humid, cold, or dry conditions, even in the trays, can contribute to paper curling prior to
printing and can cause feeding problems.
Smoothness
Paper smoothness directly affects print quality. If paper is too rough, then toner cannot fuse to it properly. If
paper is too smooth, then it can cause paper feeding or print quality issues. Always use paper between 100
and 300 Sheffield points; smoothness between 150 and 250 Sheffield points produces the best print quality.
Moisture content
The amount of moisture in paper affects both print quality and the ability of the printer to feed the paper correctly.
Leave paper in its original wrapper until it is time to use it. This limits the exposure of paper to moisture changes
that can degrade its performance.
Store paper in its original wrapper in the same environment as the printer for 24 to 48 hours before printing.
Extend the time to several days if the storage or transportation environment is very different from the printer
environment. Thick paper may also require a longer conditioning period.
Grain direction
Grain refers to the alignment of the paper fibers in a sheet of paper. Grain is either grain long , running the length
of the paper, or grain short , running the width of the paper.
For 60–90
‑
g/m
2
(16–24
‑
lb) bond paper, grain long paper is recommended.
Fiber content
Most high
‑
quality xerographic paper is made from 100% chemically treated pulped wood. This content provides
the paper with a high degree of stability resulting in fewer paper feeding problems and better print quality.
Paper containing fibers such as cotton can negatively affect paper handling.
Unacceptable paper
The following paper types are not recommended for use with the printer:
•
Chemically treated papers used to make copies without carbon paper, also known as carbonless papers,
carbonless copy paper (CCP), or no carbon required (NCR) paper
•
Preprinted papers with chemicals that may contaminate the printer
•
Preprinted papers that can be affected by the temperature in the printer fuser
Paper and specialty media guide 55