Lexicon
MPX R1 User Guide
2-6
•
Bring up the amp master volume to a point corresponding to a reasonable
listening level. (You won’t hear anything yet.)
•
Turn the MPX 1 Output Level control a little more than halfway up (at about
1:00 o’clock). You should now hear sound.
•
Compare this level with the level when the MPX 1 is disconnected from the
loop. (This is the tricky part — if your amp has a loop bypass, just bypass the
loop. If it has a loop mix control, set the control to 0%. If not, you may have
to physically disconnect the MPX 1 from the loop.)
•
Adjust the MPX 1 Output level control so that the amp's loudness is the same
as when the MPX 1 is not in the loop.
On the MPX 1:
Press System and make the following adjustments.
•
Set Pgm Bypass to Mute.
•
Set System Bypass Mode to Input Mute (delay and reverbs will “ring out”
when Bypass is on) or All Mute (effects are muted when Bypass is on).
•
Set Mix Mode to Global, press Mix and set Mstr Mix to 100%.
Adjust Mix and Level Values as follows:
•
To adjust the overall mix of dry guitar to all effects in any program, press Mix,
select Mstr Level, and change the value to suite your taste.
•
To adjust the mix or level or any of the effects in the program: press Mix,
select the Mix or Level parameter for the desired effect block and adjust. (If
you want to make the changes permanent, be sure to store your changes
before loading a new program.)
Set Input and Output Levels:
Before powering up the guitar amp, make your audio connections, turn the
MPX 1 Output Level all the way down, and turn your guitar amp master volume
all the way down.
[This is pretty simple, as you’re just adding the MPX 1 output to your normal
guitar sound.]
•
Power up the amp.
•
Load MPX Preset 100, Guitar Solo.
•
Set the preamp controls to the highest gain settings you’ll be using.
•
Turn up the Input Level control so that the 0 dB lights occasionally when
you're playing your loudest, then back it off a bit.
•
Bring up the amp master volume to the desired listening level.
•
Turn up the MPX 1 Output Level to the desired effects level.
Using a Parallel Loop
Содержание MPX R1 -
Страница 1: ...User Guide MIDI Remote Controller MPX R1 ...
Страница 18: ...Lexicon MPX R1 User Guide 3 4 ...
