TW30X
Channel number (1 to 8)
What’s on the display
Battery charge level
— when this shows
(low), make sure you have some
new batteries to hand.
DW
Dual Watch
— shown when you’re
monitoring two channels at once.
Shown when the buttons are locked.
BUSY
Shown when you’re receiving a signal.
SCAN
Shown when the handset is scanning all
channels.
VOX
Shown when the handset is in VOX
(voice-activated) mode.
Volume level
TRANSMITTING
indicator light
Display (see below)
ON/OFF button
Microphone
TALK button
Press and hold while
you’re transmitting
UP
and DOWN
buttons
Press to change the
speaker volume.
Press after the
MENU
button to
change channels
CALL button
Press to send Ring
tone to other
handsets
ENTER button
Press to switch the
backlight on and off.
Press and hold to
lock and unlock the
buttons.
Press to confirm
settings
MENU button
Press to change
channels and to
switch between
modes
MONI (monitor)
button
Press and hold to
check for signals on
the current channel
7 Troubleshooting
8 Guarantee and service
Problem
No power
Weak reception/
no reception/
noisy’ reception
Cannot change
channels
In VOX mode,
the handset
transmits all
the time
In VOX mode,
the handset
doesn’t transmit
Possible cause — solution
Batteries are low or not fitted correctly —
check;
replace batteries if necessary
Handset is not switched on —
check
Batteries are low or not fitted correctly
Other user is not within range — check
Handsets are not tuned to the same channel —
check
Volume level is too low — increase the volume
Speak in a normal voice, 5–8 cm
(2–3 inches) away from the microphone
Local conditions are impairing reception —
move to a different location
, away from
obstructions and as high as possible
You’re wearing the handset too close to your
body —
move the handset
Other user is not transmitting —
check
Other user is too close —
check
There’s interference from other users on the
same channel —
agree to use a different
channel
Handset is locked —
check
Batteries are low or not fitted correctly
Background noise is high —
move to a quieter
place
VOX sensitivity is too high —
set it to a lower
level
VOX sensitivity is too low —
set it to a higher
level
Speak in a louder voice, nearer to the
microphone
The
Lexibook
®
TW30X
is fully guaranteed for 12 months from the date of
purchase. The guarantee does not cover damage by misuse or negligence,
or by excessive voltages.
When you first unpack your
Lexibook
®
TW30X
, check for visible damage. If you
see any damage, don’t use the handsets — return the whole system to where
you bought it.
If your
Lexibook
®
TW30X
develops a fault, first check the points above. If you
can’t solve the problem, return the whole system to where you bought it.
Lexibook
®
Telecom plc operates a policy of continuous product
improvement, and so reserves the right to make changes to the product and
functions without notice.
4 Using the seconds counter
5 Cleaning and care
6 Technical specification
Press the
MENU
button FIVE times
00 flashes on the display.
To start the counter, press the
button
The counter starts running. If it reaches
99
it goes back
to
00
and starts again.
To pause the counter, press the
button
The counter flashes on the display. You can press the
button again to restart it; or …
To reset the counter to 00 press the ENTER button
while the display is flashing
When you’ve finished …
Press the MENU button once to return to normal
operation
If the handset detects a signal on the current channel
while the seconds counter is running, it will automatically
switch to normal operation and receive the transmission
The
TW30X
seconds counter (stopwatch) can count up to 99 seconds.
To
clean your
TW30X
, use a soft cloth dampened with water.
Do not use cleaners or solvents, which may cause damage not covered by the
guarantee.
Operating frequency 446.00625 to 446.09375 MHz
(eight channels)
Channel spacing 12.5 KHz
Output power 0.5 W
Channel
Frequency (MHz)
1
446.00625
2
446.01875
3
446.03125
4
446.04375
Channel
Frequency (MHz)
5
446.05625
6
446.06875
7
446.08125
8
446.09375
When the SCAN function is turned on, the handset will continuously scan through
all eight channels until it finds one on which another user is transmitting.
Scanning channels
Press the MENU button THREE times
DW appears on the display, as well as the currently
selected channel.
Press the
or
button to select a second channel
The display switches backwards and forwards between the two
selected channels. If the handset detects a signal on either channel,
it will stop and receive it.
OR, to monitor for weak signals on the channel currently shown:
Press the
MONI
button; to stop monitoring, press the
MONI
button
again
To end Dual Watch mode
Press the
TALK
,
CALL
or
ENTER
button
Monitoring two channels at once (Dual Watch)
With the buttons locked, you can transmit (
TALK
), receive or monitor (
MONI
) the
current channel. But you can’t change the volume (
) or use the
MENU
button.
Locking the buttons
Using the PMR,
continued
Press the MENU button TWICE
SCAN
flashes on the display.
Press the
or
button to start or stop scanning
When the handset detects an active channel, it will pause on that
channel.
Press EITHER
the ENTER button to set this as the current channel
the TALK button to transmit on this channel
the
or
button to continue scanning
To lock the buttons:
Press and hold the ENTER button until
appears on the
display
To unlock the buttons:
Press and hold the ENTER button until
disappears from the
display
Freephone Helpline: 0808 100 3015 - Internet site: http://www.lexibook.co.uk
We, LEXIBOOK
2, Av de Scandinavie, 91953 Courtaboeuf Cedex
declare under our sole responsibility that the product
Kind of product:
Walkie-Talkie with charger
Type number:
TW30X / MR200
to which this declaration relates, is in conformity with the following standards and/or other
normative documents.
EN300296-1-2, EN300279, EN60065
Denis Mauduit
Quality Manager
DECLARATION OF CONFORMITY
Date: June,7th 2004
We hereby declare that the above named product is in conformity to all the essential
requirements of Directive 1999/5/EC
r
