PUFP-CT-PB SERIES INSTALLATION GUIDE
It is highly recommended that in addition to reading the below installation instructions,
that the installation video is watched at
PRIOR TO INSTALLATION:
1. To ensure compliance with local electric codes, please contact your local
electrical inspector prior to installation
2. Do not install PUFP-CT prior to electrical inspector authorization.
3. Installation should only be done by a licensed and bonded electrical contractor.
4. All power must be turned off at its source prior to installation. Failure to do so
may result in injury or death.
5. All non GFI PUFP-CT series must be connected to a GFCI circuit breaker. Failure
to do so will increase the risk of injury.
6. If at any time water enters into the PUFP-CT, turn off power at its source and have
the unit replaced by a licensed and bonded electrical contractor.
7. Always use 12 or 14 gauge STRANDED wire when possible.
8. LEW ELECTRIC ACCEPTS NO RESPONSIBILITY IF THE ABOVE CONDITIONS
ARE NOT MET.
REQUIRED TOOLS:
Crimpling Pliers/ Wire Strippers, Philips Head Screw Driver, and Drill.
INSTALLATION
1. Prior to installation, a professional granite cutter should cut a 4 1/8” x 4 1/8” hole
in the desired location of the PUFP-CT.
** NOTE: When choosing a location, there
must be a minimum of 1 inch of unobstructed clearance around each side of
the hole inside the cabinet to allow the locking ring to screw onto the box.
2. Always use the supplied PUFP-PB plastic box. Unscrew the locking nut from the
bottom of the box and set aside.
3. Wiring must be completed before PUFP-PB is installed in countertop. Place
PUFP-PB box on top of countertop. Inside the cabinet, place the lock nut through the
wire. Run wiring into the ½” knock out on the side of the box furthest away from
the front of the countertop (preferred method). Alternately, if ¾” knockouts are
needed, use the knockouts in the bottom of the box furthest away from the front of
the counter.
If the knockouts are used closest to the front of the counter, the
unit will not open.
4. Strip the wires.
5. Insert the stripped wire into the quick connect terminal box making sure that no
striped wire is exposed.
