HUBBLE series
System Administrator’s
Manual
68
E-mail Settings
NVR supports e-mail notification for
Event Handling
sent through an SMTP server. To
enable this service, you will have to configure the SMTP mail settings in advance. For SMTP
service, please go to
System
Setup
page
→
System
tab
→
Network
and make sure the
Default Gateway
adopts the setting of the LAN connection that has access to the SMTP
server.
1.
Go to
System
Setup
→
System
tab
→
click “
”.
2.
Fill in
every field
according to the detailed instructions in the table below.
3.
Click “
Send Test Mail
” to send a test mail to this e-mail account. If the test mail is
sent successfully, a message saying so will pop up, which means your NVR server is
ready to send out e-mail notifications when being triggered by an event.
4.
Click “
Save
” to save these properties.
Field Name
Description
Sender Email
Input the sender’s e-mail address, should the same account you set for SMTP
server.
Server
Input the sender’s SMTP server address. Only alphabets, numbers, and the
symbols (.), (_), (-) are valid. NVR server supports the SMTP services with
SSL protocol. If you wish to use a free webmail SMTP service, you may
choose certain webmail providers such as
Yahoo
(SMTP:
smtp.mail.yahoo.com Port:25) or
Gmail
(SMTP: smtp.gmail.com Port:25 or
465 for SSL protocol / 587 for TLS protocol)
Port
Set the SMTP port, allowed value is from 1~65535, default is
25
.
1
2
3
4
