Hardware Installation
1.
Plug the included power cord into device and the
other end into an electrical socket. Then,
“PWR
” LED
is on.
2.
Connect your IEEE802.3af/at compliant Powered
Devices (PD) to port 1 to 8 and the Switch will
automatically supply power through these ports.
Now,
“
LAN
”
and
“
PoE
” LED indicator
are on.
Note:
If you connect a legacy device that is not PoE compatible,
the Switch will not deliver power to the legacy device. This feature
allows you to freely and safely mix legacy and PoE compatible
devices on your network
3.
Ensure Powered device is on. If not, please make
sure all Ethernet cables are connected correctly and
tightly.
Front Panel
Rear Panel
Grounding (Recommended)
GEP-1022 provides ancillary grounding to enhance ESD
protection.
1.
Loosen the ground screw and secure a ground wire
(not included) to the grounding point.
2.
Secure the other end of the ground wire to a grounding
block or other grounded structure.
LED Indicators
Application Diagram
Product Specification
Standard
IEEE 802.3 10Base-T
IEEE802.3u100Base-TX / 100Base-FX
IEEE 802.3ab/z 1000Base-T/ -SX/LX
IEEE 802.3az Energy Efficient Ethernet
IEEE 802.3x flow control and back pressure
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
Copper Ports
8 10/100/1000BASE-T RJ45,
auto-MDI/MDI-X
SFP Interface
2 x 1000BASE-SX/LX
Switch Architecture
Store-and Forward
Switch Fabric
20Gbps / no-blocking
Address Table
8K entries,
Automatic source address learning
Share Data Buffer
128KB
Flow Control
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex
Jumbo Frame
9K bytes
Filtering/Forwarding Rates 10Mbps port-14,880pps
100Mbps port-148,800pps
1000Mbps port-1,488,000pps
PoE Standard
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
PoE Power Supply Type End-span
PoE Power Output
Per Port 56V DC, Max. 30 watts
Power Pin Assignment
1/2(+), 3/6(-)
PoE Power Budget
60/85/115 watts
LED Indicators
PWR / LAN 1~10 / PoE 1~8
Dimension (W x H x D)
280x122x43mm
Power Requirement
100~240V AC, 50/60Hz
Certification
FCC/CE
Operating Environment
Operating temperature: 0
–
40°C
Storage temperature: -20
–
70°C
Humidity: 20
–
95% non-condensing
Note:
The device is a power-required device, meaning it won
’t work
till it is powered. If your networks should be active all the time, please
consider using UPS (Uninterrupted Power Supply) for your device. It
will prevent you from network data loss or network downtime. In
some areas, installing a surge suppression device may also help to
protect your GEP-1022 from being damaged by unregulated surge or
current to the GEP-1022.
❖
SFP Transceiver installation: The SFP transceivers are
hot-pluggable and hot-swappable. You can plug in and out the
transceiver to/from any SFP port without power down.
