LevelOne GBR-4001, Руководство пользователя, Страница: 57 / 191

Chapter 7
Advanced Configuration
http://www.level1.com Page 52
Routing name: The name of static routes (custom, no repetition).
Enable this configuration: Enables this static route. Selecting it means enabled, while
deselecting it means the route is disabled.
Destination network: The destination network number for this static route.
Subnet mask: The mask of the destination network for this static route.
Gateway address: The IP address of the next-hop router ingress. The device defines a line for
hopping to the next router through interface and gateway. Typically, the interface address and
the gateway must be on the same network segment.
Priority: Sets the priority of a static route. When the destination network, subnet mask are the
same, select the high priority routing for forwarding data, and the smaller the value is, the
higher the priority is.
Interface: The forwarding interface for the specified packets. The packets matching the static
route will be forwarded from the specified interface.
Tip :
When the destination network and priority of multiple routes are the same, the device will match
them in the principle of first matching for last establishment.
7.3 Policy routing
This section mainly describes Advanced Configuration—>Policy routing page and configuration
methods. In this page, you can define policy routing, and the packet are routed according to the
source IP addresses, protocols, destination addresses and destination ports.