Example configurations
Leuze electronic
CML 730-PS
91
11.5 Example configuration – smoothing
11.5.1 Smoothing configuration (general)
Make the following settings for smoothing.
Example: Smoothing of four interrupted beams
Example: Inverted smoothing of four interrupted beams
11.5.2 Configuration of smoothing via IO-Link interface
Assign the desired value for smoothing.
Example: Smoothing of four interrupted beams
Example: Inverted smoothing of four interrupted beams
11.6 Example configuration - Cascading
11.6.1 Configuration of a cascading arrangement (general)
The following figure shows an example for a timing sequence of a cascading arrangement with three light
curtains.
Blanking settings
(group 8)
Index 76, bit offset 200:
= 0
No blanking areas permitted
Index 76, bit offset 192:
= 0
Automatic blanking area configuration not active
Blanking settings
(group 8)
Index 76, bit offset 176:
= 0
No beams blanked
Index 76, bit offset 176:
= 0
No beams blanked
System commands
(group 1)
Index 2:
= 162
Execute teach
Smoothing settings
Parameter
Smoothing -– less than i interrupted
beams are ignored
:
= 4
Beams are taken into account in the evaluation once
there are four or more interrupted beams
Smoothing settings
Parameter
Inverted smoothing - less than i free
beams are ignored
:
= 4
Beams are taken into account in the evaluation once
there are four or more free beams
If the set configuration of the light curtain is running stably in your application and the measure
-
ment field resolution can be reduced, e.g. in the case of objects to be detected which are con
-
siderably larger than 10 mm, it is recommended to set
Smoothing
and
Inverted smoothing
to a
value > 1.
General configuration
(group 4)
Index 71, bit offset 8:
= 4
Beams are taken into account in the evaluation once there are four or more
interrupted beams
General configuration
(group 4)
Index 71, bit offset 0:
= 4
Beams are taken into account in the evaluation once there are four or more
free beams
